Scan Mode Operation; Using The Radio In Scan Mode - Uniden MHS115 Owner's Manual

How it Works?

Scan Mode Operation

You can save channels into memory and then use Scan mode to monitor
those channels from lowest to highest. If the radio detects a signal on a
channel, it stays on that channel as long as the signal is received; when the
signal stops, the radio continues scanning.
When it detects a signal, the radio stays
on the channel until you press the
Channel Up button or the signal stops.
08 10
The radio scans about
5 channels in 0.5 seconds.

Using the radio in Scan Mode

• To activate Scan mode, press SCAN/MEM.
• You must have at least two channels in memory to start a scan. However,
you cannot save marine channel 70 or Weather channels.
• You cannot transmit while in Scan mode.
• To save a channel into memory, select the channel, then press and hold
SCAN/MEM. The MEM icon displays whenever you tune to that channel.
• To remove a channel from memory, set the radio to that channel, then
press and hold SCAN/MEM. The MEM icon no longer displays.
• When the radio stays on a channel, press Channel Up to leave that
channel and resume scanning.
• To end the scan, press the SCAN/MEM button again; the radio remains on
the last scanned channel.
UNIDEN MHS115
11 12 13
14
14
Handheld VHF Marine Transceiver
Resume
scan
17
15