Table of Contents
Advertisement
E N G L I S H
K. TILT-IN-SPACE MECHANISM
The tilt-in-space mechanism is installed by Sunrise. Two cable/trigger mechanisms positively
lock the chair in place from -5º to 60º depending on the set-up. The Quickie/Zippie IRIS has
the capability to provide from 0º to 5º of forward tilt. DO NOT ATTEMPT TO MAKE THIS
ADJUSTMENT. This adjustment must be done by an authorized supplier.
1. Trigger Tilt Operation
a. Depressing both triggers (C) at the same time disengages the locking mechanism and
allows the seat and back to rotate in space. Releasing the triggers positively locks the
rockers in place.
b. The approximate degree of tilt the seat is at can be seen on the tilt indicator (D).
c. To lock out the tilting function, insert the locking pin (E) into the trigger holder.
18
19
2. Foot Release
a. Depressing foot pedal (F) disengages the locking mechanism and allows the seat and
back to rotate in space. Releasing the foot pedal positively locks the rockers in place.
b. The approximate degree of tilt the seat is at can be seen on the tilt indicator (D).
3. Tilt-stops Adjustment
Adjustments can be made to limit the amount of tilt (rotation) that the chair provides by
using the tilt-stops (G).
a. Loosen and remove the retaining screw (H).
b. Locate the tilt-stops to the desired limit either anterior or posterior.
c. Each half of tilt stop assembly should plug into directly opposing holes on the rocker
(I), then secure in place by tightening the screw (H).
21
4. Cable Adjustment
NOTE– Do not use lubricants on the components or assembly.
a. Loosen the jam nut (A).
b. Rotate the cable adjuster (B) until slack is removed from the cable. Make sure the
plunger pin can fully extend and retract after adjustment and that pins engage the rock-
er when triggers are released.
c. Tighten jam nut (A).
L. BACKREST AND STROLLER HANDLE (Optional)
22
1. Angle Adjustment
a. Loosen rear bolt (C).
b. Loosen and remove angle adjustment bolt (D).
c. Set backrest at desired angle using pre-set holes.
d. Replace and tighten the front bolt (D).
e. Tighten rear bolt (C).
f. Repeat on other side.
IMPORTANT NOTE– The adjustment on each side of the chair should be exactly equal.
NOTE–
Use a torque setting of 240 in.-lbs. When setting-up the angle adjustment of the stroller handle.
NOTE–
Backrest position may also need adjusting to maintain optimal CG alignment and stability.
17
18
20
17
IX. SET-UP & ADJUSTMENT
17
E
C
18
D
19
F
20
I
G
H
21
A
B
22
C
D
113373 Rev. C
Advertisement
Table of Contents
