Table of Contents
Advertisement
E N G L I S H
O. FRAME DEPTH
29
30
1. Back adjustment
a. Loosen and remove the bolts (C & E) located in front of back mounting plate on both
sides of the chair.
b. Slide the backrest along the seat rail to the desired position.
c. Replace and tighten the bolts (C & E) at desired position on both sides of chair.
IMPORTANT NOTE– The adjustment on each side of the chair should be exactly equal.
NOTE– Use a torque setting of 120 in.-lbs. When setting-up back depth adjustment.
2. Hanger Receiver Adjustment
a. Loosen and remove both socket head screws (F) from the seat rail.
b. Slide the hanger receiver (G) in the seat rail to the desired position.
c. Replace and tighten the socket head screws.
d. Repeat on the other side.
IMPORTANT NOTE– These adjustments may also require re-positioning the carriage over the base frame,
refer to matrix in the ordering guide for recommended location.
IMPORTANT NOTE– The adjustment on each side should be exactly equal.
NOTE– Use a torque setting of 120 in.-lbs. When setting-up hanger receiver.
P . FRAME WIDTH
The frame of the IRIS is built to accommodate growth by using the growth kit components.
Width Adjustment
a. Remove the bolts (H) from both ends of the strut tubes (I) for all strut tubes.
b. Replace with the appropriate length strut tubes
c. Tighten the bolts (H) at each end.
d. Repeat for each strut tube.
NOTE–
Use a torque setting of 200 in.-lbs. when setting up rocker frame width.
Use a torque setting of 150 in.-lbs. when setting up base frame.
31
32
33
19
IX. SET-UP & ADJUSTMENT
29
D
E
C
30
E
C
D
31
F
G
32
I
H
33
I
H
113373 Rev. C
Advertisement
Table of Contents
