@8
[
\6
::==::...,
5
3
7
4
Circular saw blade 200
(chisel and scratcher tooth)
Fit the appropriate stop
before mounting circular saw blade.
Fitting the stop see chapter "Mounting
the Deflector".
30
Mounting circular saw blade
•
Lay your brushcutter on its back
with the gear head facing up.
•
Position saw blade (3) on
the thrust plate (4) -
teeth must point in clockwise
direction.
•
Slip the thrust washer (5)
and rider plate (6) over
the drive shaft (7).
•
Block the drive shaft.
•
Screw mounting nut (8)
counterclockwise on to
drive shaft and tighten down
securely.
Releasing mounting nut
•
Block the drive shaft and
unscrew the mounting nut
clockwise.
If the mounting nut becomes slack due
to frequent loosening and retightening, fit
a new one.