t
l
Releasing mounting nut
•
Block the output shaft.
•
Unscrew the mounting nut
clock wise.
If the mounting nut becomes slack due
to frequent loosening and retightening,
fit a new one.
Fitting nylon line
•
Refer to instruction sheet supplied
with fixed line head.
Grass cutting blade 230
Brush knife 250
Note: Remove skirt and blade from
deflector before mounting these
cutting tools.
•
Lay your brushcutter on its back
with the gear head facing up.
•
Place cutting tool (1) on the thrust
plate (2).
•
Cutting edges of blade 230-8 (3)
must point clockwise.
•
Cutting blade 230-4 (4) and brush
knife (5) may be fitted either way
round.
•
Slip the thrust washer (6)
and rider plate (7) over
the output shaft (8).
•
Block the output shaft.
•
Screw mounting nut (9) counter-
clockwise on to output shaft and
tighten down securely.
Important!
Remove the stop pin.
Releasing mounting nut
•
Block the output shaft.
•
Unscrew the mounting nut
clockwise.
If the mounting nut becomes slack due
to frequent loosening and retightening,
fit a new one.
29