Replacing Starter Rope
and Rewind Spring
2
~
0
0
5
'-6
0
]ID__
2 _ -
Sharpen correctly
•
File only the back of the tooth (1).
•
If slightly dull: Use
flat file (2) 0814 212 3310.
In case of more serious wear or
nicks: Resharpen with a grinder -
until the tips (3) of the teeth are
restored to full sharpness.
•
Resharpen frequently, take away
as little material as possible - two or
three strokes of the file are usually
enough.
•
Do not alter tooth profile.
Removing rewind starter
•
Lay your brushculler on its back
with the gear head facing up.
•
Remove the four screws (1) from
the machine support (2) and lift it
away.
•
Take out the screws (3).
•
Remove the starter cover (4)
together with rewind starter
mechanism.
Replacing a broken starter rope
•
Take out the screw (5).
•
Remove the washer (6).
•
Remove the rope rotor very
carefully - the rewind spring is
seated in the starter cover and
may pop out and cause injury if
care is not taken.
48