Sunrise Medical Quickie Ti Titanium User Instruction Manual & Warranty page 19

36
3. Turning Anti-Tip Tubes Up
Turn anti-tip tubes up when being pushed by atten-
dant, overcoming obstacles or climbing curbs. Press
the rear anti-tip tube release lever. Hold lever in and
turn anti-tip tube up. Release the lever and repeat
with second anti-tip tube. Remember to return anti-tip
tubes to down position after completing maneuver.
N. CHECK-OUT
After the wheelchair is assembled and adjusted, it
should roll smoothly and easily. All accessories should
also perform smoothly. If you have any problems, fol-
low these procedures:
a. Review assembly and adjustment sections to make
sure chair was properly prepared.
b. Review trouble shooting guide.
c. If your problem persists, contact your authorized
supplier. If you still have a problem after con-
tacting your authorized supplier, contact Sunrise
customer service. See the introduction page for
details on how to contact your authorized sup-
plier or Sunrise customer service.
930487 Rev. B
I X . S e t - U p & A d j u s t m e n t X . T r o u b l e s h o o t i n g
You will need to adjust your chair from time to time for best performance (especially if
you alter the original settings). This chart gives you a first solution, then a second and a
third if needed. You may need to look farther to find the best solution for a specific
problem.
NOTE– To keep track of your progress, make only ONE change at a time.
   
Make sure tire pressure is correct and equal in
both rear tires and front caster tires, if pneumatic.
   
Make sure all nuts and bolts are snug.
 
Make sure all spokes and nipples are tight on
radial spoke wheels.

Use Tri-Flow Lubricant (Teflon®-based) between
all modular frame connections and parts.
   
Check for proper caster housing adjustment. See
instructions for caster adjustment.

Check for proper toe-in/out adjustment. See
instructions for proper adjustment.
SOLUTIONS
930487 Rev. B
37