Service Menu - JabloCom GDP – 02 User Manual

JABLOCOM
S M
ERVICE ENU
From the standby screen type SERVICE on the QWERTY keypad (the words will not be shown on the display and the phone will beep during
typing). The Service menu will open. If you make a mistake while typing, pick up the receiver and hang up before making a new attempt. You can
scroll through the following options:
•
Firmware version – shows FW version and IMEI of the phone.
•
Display contrast – select a number using the scroll keys.
•
Backlight – select a number using the scroll keys to set the LCD backlight level for standby mode if powered by AC adapter.
•
Volume control – adjusts the volume for microphones, speakers and tones.
•
Battery voltage – displays battery voltage.
•
Factory settings – restores factory default settings and erases all items in the memory: Phonebook, Messages, Call registers. The Date
and time will not change.
The following special function codes can be entered in the service mode:
•
*P1# – activates unprotected access – users do not need to enter a PIN code to access their SIM card (factory setting).
•
*P0# – deactivates the function mentioned above – users must enter their PIN code to access their SIM card.
•
*A1# – activates automatic switch-on – connecting the AC power supply will automatically switch-on the phone (factory setting).
•
*A0# – deactivates the function mentioned above – connecting the AC power supply will not automatically switch-on the phone.
•
*N1# – activates the display of a network name on the LCD panel (factory setting) – i.e., the network name in which the phone is currently
registered will be displayed, some special SIM cards may show their own phone number instead of a network name.
•
*N0# – deactivates the function mentioned above – removes the network name displayed on the LCD panel.
•
*S0# – deactivates the function of SMS sending confirmation for test messages with more than 160 characters.
•
*S1# – activates the function of SMS sending confirmation for test messages with more than 160 characters.
•
*E0# – deactivates the function of automatic SMS replacement if the incoming SMS memory is full. User is required to erase messages
from inbox.
•
*E1# – activates the function of automatic SMS replacement if the incoming SMS memory is full. Phone erases the oldest message from
inbox automatically.
•
*R0# – deactivates the function of automatic SMS status report. If the function is not active, messages remain in "being delivered" status
with "winged" envelope displayed.
•
*R1# – activates the function of automatic SMS status report.
•
*Dxy# - sets date format where x represents date format (1 = german DDMMYY, 2 = american MMDDYY, 3 = japan YYMMDD) and y
represents date separator(1 = ".", 2 = "-", 3 = "/")
The # sign always ends each coded sequence. Afterwards the phone displays "OK" if the code was entered properly or "Error" if the code
was entered incorrectly. The codes listed above can only be entered when the phone is in the service mode. All parameters are set to
default ones if the language is changed.
HB53019_ENG.doc
13
User's Guide
www.jablocom.com