Sony DCR-HC39E Service Manual page 198

Application of grease, soldering method and precautions, and phase
Apply grease (1)
Tension spring
(Tension regulator)
During installation, apply grease in the TG2 arm pivot shaft hole.
Amount of grease: a ball of grease of 1.0 mm diameter
(Note)
Worm shaft
Deceleration gear
DV MECHANICAL ADJUSTMENT MANUAL VII
HELP
matching adjustment are compiled and below.
TG2 arm block assy
Gooseneck gear shaft
Amount of grease: a ball of
grease of 1.0 mm diameter
(Note)
• Do not apply grease to the
wrong position.
• Do not forget to apply grease.
• Do not make mistake about amount of grease.
• When applying grease, do not splash or touch
grease to any other parts and components.
Apply grease
Amount of grease to be applied
: 2.0 mm dia (at 2 locations)
Note: Re-application of grease to the point which
is greased already before is not necessary.
TG7 arm block assy
Apply grease on the supporting surface of the TG7
pivot shaft.
Grease application point:
Amount of grease:
a ball of grease of 0.5 mm
diameter
(Note)
TG7 pivot
Supporting surface
shaft
Apply grease
Gooseneck gear shaft
2003.01.30
Gooseneck
gear assy
HELP