Tape Operation; Repeat Play; Index Search - Panasonic PV-DF2003-K Operating Instructions Manual

Tape Operation

Search System is ...
Each time a recording is made, an invisible index
mark is placed on the tape. When timer recordings
are made, program index and information are
also included. These index marks can be used to
access or scan recordings.

Index Search

Go directly to the desired recording.
1
I NDEX SEARCH
ENTER I NDEX NUMBER : 1
US I NG 1- 9 KEYS
FORWARD SEARCH
REVERSE SEARCH
EX I T : SEARCH
Press FF or REW to start search.
2
I NDEX SEARCH
FORWARD SEARCH
REVERSE SEARCH
To cancel, press PLAY.
Note
• If Index Search is started very close to an index mark,
that index mark may not be counted in the search.
■ To calculate the Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press
REW.
1 2 3
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
1 2 3
NOTE: indicates start points of each recording.
36
Press SEARCH*
in Playback or
Stop mode to
display INDEX
: FF
SEARCH screen,
: REW
and then press
NUMBER keys to
select the
recording number.
• To calculate
number, see below.
Playback begins
at search end. To
search forward
or back 1 index,
press FF or REW
while screen left
: FF
: REW
is displayed (10
seconds).
4 5 6 7
4 5 6 7

Repeat Play

Set to see a recording over and over.
PLAY
REPEAT ON
To turn "ON,"
press PLAY/REPEAT on the unit repeatedly in
Playback mode to select "REPEAT ON."
To turn "OFF,"
repeat above to select "REPEAT OFF."
• Playback repeats when tape end is reached or
an unrecorded portion longer than 30 seconds is
detected.
Note
• For repeat play in DVD mode, see pages 60-61.
Commercial Skip
By pressing the CM/ZERO button in Playback mode
you can skip over 1 to 3 minutes of recorded tape in
just a few seconds.
Press CM/ZERO repeatedly to select skip
time in Playback mode.
• No indication appears.
OFF
1st Press 1 min skip
2nd Press 2 min skip
3rd Press 3 min skip