Copy Your Tapes (Dubbing); Selecting Input Mode - Panasonic PV-DF2003-K Operating Instructions Manual

Copy Your Tapes (Dubbing)

* Important: If a remote control button does not work when pressed, press the
the button again.
Connections you'll
need to make
Playing (Source) VCR
R-AUDIO OUT-L VIDEO OUT S-VIDEO OUT
If cables are connected to both connectors (S-VIDEO IN or VIDEO IN), the S-VIDEO
signal will be selected automatically. (The S-VIDEO signal has priority.) If you would
like to display the VIDEO signals being input to the VIDEO IN connector, do not
connect any cables to the S-VIDEO IN connector.
Playback (Source)
1
Insert pre-recorded
tape.
2
Press PLAY then press PAUSE at starting
3
point to put in Standby mode.
(Perform operation of steps 4 and 5 on both units at same time.)
4
Press PLAY to start dubbing.
Press STOP to stop dubbing.
5
Caution
• Unauthorized exchanging and/or copying
of copyrighted recordings may be copyright
infringement.
• Please note that some tapes cannot be dubbed
on this unit. Also, it is not possible to dub
DVD/Video CD/CD to VHS tape using this unit.
Recording (Editing) unit
Front
VIDEO IN2 L-AUDIO IN2-R S-VIDEO IN2
Recording (Editing) unit
Select "LINE" mode.
See "Selecting Input Mode" below.
Press REC, then press STILL/PAUSE
immediately to put in Standby mode.
Press STILL/PAUSE to start dubbing.
Press STOP to stop dubbing.

Selecting Input Mode

Method 1:
Press CH
Method 2:
a Press ACTION for MAIN MENU.
b Press
for SET UP TV screen.
c Press
then press SET to select "TUNER," "LINE1" or
"LINE2."
d Press ACTION twice to exit this mode.
button on the remote and try
Back
R-AUDIO IN1-L VIDEO IN1 S-VIDEO IN1
Insert blank tape with
record tab.
• Dubbing tapes protected with
Copy Guard will have poor
quality results.
. The display will change as follows.
1
LINE2 2
(CABLE)
or
LINE1 125
to select "TV," then press SET
to select "INPUT SELECT," and
3
(TV)
69
21