Duracell Powerpack Pro 300 Owner's Manual page 29

WARNING: Acid spills
Use a sealed, non-spillable battery for indoor use.
Common auto and marine batteries are not suitable
for indoor use unless their fumes are vented outdoors.
Common auto and marine batteries contain acid, which is
hazardous if spilled. Wear eye protection and protective
clothing when connecting the Duracell
an external battery.
To connect the Duracell
external battery using the jump-start cables
1. Ensure that the jump-start power switch is OFF.
2. Connect the red positive (+) clamp of the cables to the
positive (+) terminal of the external battery.
3. Connect the black negative (–) clamp of the cables to
the negative (–) terminal of the external battery
If the "Clamps Reversed LED" illuminates and the
alarm sounds, then reverse polarity has been detected.
Correct polarity must be established before
proceeding.
Disconnect the jump-start clamps from the battery and redo
steps 2 and 3 in this procedure.
Switch ON the jump-start power switch.
To disconnect the cables from an external
battery:
1. Ensure that the jump-start power switch is OFF.
2. Remove the red positive (+) clamp, and then remove
the black negative (–) clamp from the external battery
terminals.
3. Store the jump-start clamps in the appropriate holder
on each side of the Duracell
4. Recharge the Duracell
possible after use.
Powerpack Pro to an
®
®
Powerpack Pro.
®
Powerpack Pro as soon as
19
®
Powerpack Pro to
: