Duracell Powerpack Pro 300 Owner's Manual page 23

3. Fully recharge the Duracell
possible after each use.
As the DC power outlet is internally wired directly to the
Duracell
of a 12V DC appliance may result in excessive battery
discharge. See "Caution for equipment damage" on this
page.
Note: Please refer to the "User Reference" section on
Page 25 for examples of typical DC device run times
using the Powerpack Pro.
► Jump-starting a vehicle's engine
You can use the Duracell
jump-start cables to jump-start a vehicle or boat engine that
has a 12V starting battery.
WARNING: Fire hazard
Never allow jump-start cables' red and black clamps to
touch each other or another common metal conductor.
This could cause damage to the unit and/or create a
sparking/explosion hazard. Always switch OFF the
Jump-Start power switch and store the jump-start clamps
in the appropriate holder on each side of the Duracell
Powerpack Pro after use.
WARNING: Fire hazard
Jump-start cable clamps' connection to the vehicle's
battery terminals must be positive to positive (red clamp to
battery "+") and negative to engine block. A reverse polarity
connection (positive to negative) may cause damage to the
unit and/or create a sparking/explosion hazard.
Important:
starting your vehicle because they may be different from
the instructions supplied with other products or jump-start
cables.
®
Powerpack Pro's battery, extended operation
Closely follow these instructions for jump-
®
Powerpack Pro as soon as
®
Powerpack Pro with the supplied
13
®