Charging/Recharging With The Ac Cord - Duracell Powerpack Pro 300 Owner's Manual

Charging / recharging with the AC cord
1. Disconnect any 12V DC appliances from the DC power
outlets.
2. Insert the AC cord end into the AC cord input socket
located below the front panel (see Page 3).
3. Plug the AC cord into a standard AC wall outlet. The
Battery Status LED changes from red to green when
charging is complete (about 24 hours if the battery is
completely discharged).
Important:
Powerpack Pro assumes that there is 120 V AC at the
AC wall outlet. If the voltage is less than 120 V AC, it may
take more than 24 hours to fully recharge the Duracell
Powerpack Pro If, after 24 hours of charging, the Battery
Status LED remains red, continue to charge the unit for
another 12 hours. The unit will be ready for use even if
the Battery Status LED remains red.
Important:
for use with certain products and loads. See Precautions
on Page 24.
Important: If you keep the Duracell
storage, the battery will discharge over time. Remember
to recharge the battery every three months to keep the
Duracell
Note: Once fully charged, the charging current
automatically reduces to a maintenance charge
mode, and the Duracell
permanently connected to the AC cord.
The 24-hour charging time for the Duracell
The Duracell
®
Powerpack Pro operational.
®
Powerpack Pro is not suitable
®
®
Powerpack Pro may be left
8
Powerpack Pro in
®
®