80% usage target. ❍ Mast Assemblies (boxed) ❍ Boat Stand NOTE: Your Bristol Trawler’s ESC has a stutter bump warning system that warns you of low battery voltage. This system starts its warning at 10.2V total giving you time to bring the Parts Needed to Complete Your Model boat back to shore before the ESC cuts off at 9.2V.
Dimensions: 35 mm × 34 mm × 9 mm time you enter your retrieval craft. Servo Connector: Universal ● AquaCraft products are to be used by ages 14 and over. ● Do not touch the propeller anytime the motor is running. Pay Boat Terminology...
If you power, then it will pause for 1 second and beep again to need any help you can always call Product Support or refer confirm it is armed. to pictures on the AquaCraft Models website.
Page 5
Clip the mast lighting connector to one of the two loose ends inside the cabin. Insert the forward mast (the longest one) into the forward deck mounting hole. Start by fishing the lower wires for the lighting system through the hole, then follow with the mast. A Next, install the rear mast.
Page 6
POSITIONING THE OUTRIGGERS You might also buy some line to make a lanyard leading from the aft mast to aid in the attachment to the top of the aft mast. This really has more to do with your liking but we will describe Different length lanyards provide you with a variety of boom the attachment positions for the outriggers.
Ordering Replacement Parts To order replacement parts for the AquaCraft Bristol Trawler, use the order numbers in the replacement parts list. Replacement parts can be purchased from your local hobby shop or by mail At this time you can also install two AA batteries into the order.
Need help?
Do you have a question about the Bristol Trawler and is the answer not in the manual?
Questions and answers