Factory Defaults; Setting Up Your Computer's Ip Address - ZyXEL Communications ZyAIR G-4100 Quick Start Manual

LED STATUS
ZyAIR On (Blue)
Blinking (Blue)
LAN (1-4) On (Green)
Blinking (Green)
Off
WAN On (Green)
Blinking (Green)
Off
SYS On (Green)
Off
PWR On (Green)
Off

1.4 Factory Defaults

Username "admin" (case sensitive)
Password "1234"

2 Setting Up Your Computer's IP Address

Skip this section if your computer is already set up to accept a dynamic IP
address. This is the default for most new computers.
The ZyAIR is already set up to assign your computer an IP address. Use this section to set up your
computer to receive an IP address or assign it a static IP address in the 192.168.1.2 to 192.168.1.254
ZyAIR G-4100
Table 2 Front Panel LEDs
The ZyAIR is ready, but is not sending/receiving data through the wireless
LAN.
The ZyAIR is sending/receiving data through the wireless LAN.
The port is connected to a 10/100Mbps Ethernet device.
The port is receiving or sending data.
The port is not connected to a 10/100Mbps Ethernet device.
The WAN port has a connection to your cable or DSL modem.
The WAN port is sending or receiving packets.
The WAN link is not ready, or has failed.
The ZyAIR is ready and running.
The ZyAIR is not ready or has failed.
The ZyAIR is receiving power.
The ZyAIR is not receiving power.
Table 3 Factory Defaults
WAN IP Address
LAN IP Address
LAN DHCP
6
DESCRIPTION
DHCP Client (dynamic WAN IP)
192.168.1.1
Server