Maintenance; General; Maintenance Schedule; Cleaning - Husqvarna Soff-Cut 150 Operator's Manual

General

WARNING! The user must only carry out the
!
maintenance and service work described in
this manual. More extensive work must be
carried out by an authorized service
workshop.
The engine should be switched off during
operations described in this chapter unless
otherwise stated.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
The life span of the machine can be reduced
and the risk of accidents can increase if
machine maintenance is not carried out
correctly and if service and/or repairs are
not carried out professionally. If you need
further information please contact your
nearest servicing dealer.
Let your Husqvarna dealer regularly check the machine and make essential adjustments and repairs.

Maintenance schedule

In the maintenance schedule you can see which parts of your machine that require maintenance, and with which intervals it should
take place. The intervals are calculated based on daily use of the machine, and may differ depending on the rate of usage.
Daily maintenance
External cleaning

Cleaning

General inspection
Skid plate
Lexan cover*
Check Blade block guard*
Blade**
Fuel level***
Oil level
Change
Greasing
*See instructions in the section "Machine's safety equipment".
** See instructions in the section "Blades" and "Assembly and settings".
***See instructions in the section "Fuel handling".
Cleaning
External cleaning
• Clean the machine daily by rinsing it with clean water after the work is finished. Keep the handles clean and dry.
• Clean the blade block of any excess concrete build up after each use. Use a heavy-duty hand-held brush or a large paint brush.
• If you have spilled fuel or chain oil on the machine. Wipe off the spillage and allow remaining fuel to evaporate.
• Keep all openings and slots on the saw clean open so air flows freely through the engine compartment to ensure proper cooling.
20 –
English

MAINTENANCE

Weekly maintenance/40 hours
Air cleaner
Spark plug
Drive belt
Oil (After the first 20 h then every
100 h)
Blade shaft bearings
Monthly maintenance/200 hours
Fuel cup
Spark plug and electrode gap
Air cleaner element