Iscsi Configuration - Asus Z10PA-U8/10G-2S User Manual

USB hardware delays and time-outs
USB transfer time-out [20 sec]
The time-out value for control, bulk, and interrupt transfer.
Configuration options: [1 sec] [5 sec] [10 sec] [20 sec]
Device reset time-out [20 sec]
USB mass storage device start unit command time-out.
Configuration options: [10 sec] [20 sec] [30 sec] [40 sec]
Device power-up delay [Auto]
This is the maximum time the device will take before it properly reports itself to the host
controller.
Configuration options: [Auto] [Manual]
Mass Storage Devices
The following item appears only when a USB device is detected by the system.
Generic 8.07 [Auto]
Allows you to select the mass storage device emulation type.
Configuration options: [Auto] [Floppy] [Forced FDD] [Hard Disk] [CD-ROM]
4.4.13

iSCSI Configuration

Allows you to configure the iSCSi parameters.
4-24
Chapter 4: BIOS setup