User Options; Changing The User Options' Settings; Table Of User Options - Linn UNIDISK SC PLAYER Owner's Manual

User Options

English
User Options
This chapter explains how you can configure certain functions of the UNIDISK SC to suit
your own requirements.

Changing the user options' settings

T U N E R
ALL ONE A - B
DISP
RANDOM SHUFFLE INTRO
GOTO
INCLUDE EXCLUDE RECORD
SURR
ADJUST
STORE SHIFT
TV
TITLE DVD
'enter'
SETUP RETURN
+
PRESET TUNE SCAN
--
SIGNAL BAND MONO
+
--
AUDIO SUB-T ANGLE ZOOM
ALARM
TIMER WHERE WHAT DO
To access the user options:
If there is a disc playing in the unit, stop it.
Hold on the front panel until the display shows User Options.
To change the user options' settings:
Repeatedly press or hold or
required user option.
Repeatedly press or hold or
To restore a user option to its default value:
Select the required user option.
Press 'enter' on the handset or
To save settings and exit the user options:
Press on the handset or on the front panel.
UNIDISK SC PLAYER
Owner's Manual
SELECT
U N I D I S K S C
on the handset or front panel to select the
to change the setting of the user option.
on the front panel.

Table of user options

The following table shows the UNIDISK SC's user options, describes them and lists the
available settings for each. Default settings are shown in bold (and are marked with a '
on the front panel display).
Option Description
DISPLAY BRIGHTNESS Allows adjustment to the brightness of the
front panel display. When set to AUTO, the
unit will select a brightness level based on
the ambient light level in the room (the
greater the ambient light level, the brighter
the display will be).
SLEEP DISPLAY DELAY Sets the number of seconds that the unit is
inactive for before the sleep display (three
dots) is shown on the front panel.
FRONT PANEL IR If set to ACCEPTED, unit will respond to
COMMANDS commands received via the IR receiver on
the front panel.
ACC SOCKET MODE Defines the use of the ACC (accessory)
socket. IR = Infrared Repeater,
RCU = KNEKT Room Control Unit.
IR OUT MODULATION Modulation frequency for infrared flasher.
KNEKT MODE AUTO is the setting for normal operation and
is also for use when the unit is in a KNEKT
system and is connected to another UNIDISK
SC, a Linn CLASSIK Movie,
CLASSIK Movie Di, or CLASSIK Music. In this
situation the UNIDISK SC will automatically
configure itself to operate as a Main or Local
Room component.
The MAIN and LOCAL options allow you to
specify whether the unit is a Main or Local
Room component in a KNEKT system.
The SOURCE setting disables the unit's pre-
amplifier and should be used if the
UNIDISK SC is being used with an external pre-
amplifier or surround sound processor.
PASS IR TO REMOTE OUT If set to ENABLED, the unit passes commands
(This option will not be received via the IR receiver on the front panel
available if KNEKT MODE to REMOTE OUT. Will function even if the IR
has been set to AUTO, commands are disabled.
MAIN or LOCAL.)
30
'
*
Settings
AUTO
2% to 100%
(non-linear)
OFF
0m 10s to 5m 00s
(in 10 sec steps)
ACCEPTED
IGNORED
IR
RCU
36 kHz
10 kHz to 2212 kHz
AUTO
MAIN
LOCAL
SOURCE
ENABLED
DISABLED