Linn UNIDISK SC PLAYER Owner's Manual page 17

The next menus allow speaker distances to be described to the UNIDISK SC so that the
unit can add time delays to certain speakers. This ensures the sound from all the
speakers reaches your seating position at the same time.
Front Posn.
(position)
Default setting: 1.5 m/5 ft
Calculate the approximate distance between your
seating position and your front speakers.
Highlight the 1.5 m/5 ft option then use the
the handset or front panel to increase the distance
shown (up to 9.2 m/30 ft).
Select the appropriate distance by pressing 'enter' on the handset or front panel.
Centre Posn.
(position)
Default setting: 1.5 m/5 ft
Calculate the approximate distance between your
seating position and your centre speaker.
Highlight the 1.5 m/5 ft option then use the
the handset or front panel to increase the distance
shown (up to 9.2 m/30 ft).
Select the appropriate distance by pressing 'enter' on the handset or front panel.
Surround Posn.
(position)
Default setting: 1.5 m/5 ft
Calculate the approximate distance between your
seating position and your surround speakers.
Highlight the 1.5 m/5 ft option. Use the
handset or front panel to increase the distance shown
(up to 9.2 m/30 ft).
Select the appropriate distance by pressing 'enter' on the handset or front panel.
Note:
It is not necessary to set the position for a subwoofer.
key on
key on
key on the
Test Tone
For maximum enjoyment of your UNIDISK SC, it is important to ensure that the volume
level reaching your seating position is the same for each speaker in your system.
Speaker volume trim is adjusted using the unit's test tone feature.
When set to On, a tone signal is sent to all speakers (except a subwoofer*) starting with
the front left and moving in a clockwise direction.
To perform speaker volume trim:
Set Test Tone to On. The test tone display appears
on the UNIDISK SC's front panel.
Wait for the test tone to reach the speaker you
wish to adjust (your display device and the front
panel indicate which speaker the tone is emitting
from).
Repeatedly press or hold VOL - / + on the
handset to trim the volume as required.** Volume
trim range is –10 to +10 (in 0.5 steps) with neutral trim being 0.
A few seconds after the VOL - / + key has been released, the test tone will continue its
clockwise direction.
To exit speaker volume trim:
Set Test Tone to Off.
* For subwoofer adjustment– see Subwoofer trim in Pre-amplifier chapter.
**You can do this by ear or by using a Sound Pressure Level meter.
11
Setup Menus
English
UNIDISK SC PLAYER
Owner's Manual