Axis 291 1U Installation Manual page 6

AXIS Video Server Rack Installation Guide
AXIS blade video servers
S/N - (serial number) is identical to the unit's MAC/Ethernet address,
e.g. 00408C1A2B3C = 00-40-8C-1A-2B-3C.
P/N - is the product's model number.
Bus Connector - This is the physical interface to the I/O terminal connector on the rack.
DIP Switches (4-port models) - Each video input has a corresponding line termination DIP switch.
Axis blade video servers are supplied with the line termination enabled for each input; i.e. with the
DIP switches set to ON (down position). To connect the video server in parallel with other
equipment, disable the input termination by setting the corresponding DIP switch to OFF (up
position). Failure to do so may affect the image quality negatively.
Bus
Connector
DIP Switches (1-port models) - These models can accommodate either composite or Y/C video.
The type to use is determined by the DIP switch settings. 1-port AXIS blade video servers are
supplied configured for composite video input, as shown in the table below.
Switch
Description
Composite video
input
Y/C video input
1
75 ohm video in 75 ohm video out
termination termination
on
on
DIP Switches
2 3
Connects video in
and video out
off on
on off
Page 7
4 Video inputs
S/N & P/N label
4
Not used
n/a
n/a