Attaching The Brackets - Axis 291 1U Installation Manual

AXIS Video Server Rack Installation Guide
Installation in a 19" equipment rack
Requirements
• Pozidriv screwdriver #1
• Pozidriv screwdriver #3
• The rack must be braced and bolted to the floor.
• The AXIS Video Server Rack must be grounded to the same ground as the equipment
rack.
When mounting the AXIS Video Server Rack in a rack, never stack other units directly on top - the
mounting brackets are not designed to support more than 1 unit. Each unit in the rack must be
secured with appropriate brackets. Place the heaviest units at the bottom of the rack.

Attaching the brackets

The 2 mounting brackets are slightly different. To tell these apart, see the label on each bracket. See
also the illustration on page 3.
1. Remove the screw shown here from
each side of the unit. These will be
replaced by the screws used to fasten
the bracket.
2. Using the recessed M3X8 screws,
fasten the bracket to the side of
the unit. Do not use the screw that
was removed in step 1.
3. Slide the AXIS Video Server Rack
into the equipment rack. Insert the
M6X20 screws and tighten.
Page 5