Linksys SFE2010 Admin Manual page 35

1. IPv6 Interface Enable (see page 32)
2. IPv6 Address Settings (see page 33)
3. IPv6 Address Table (see page 34)
4. IPv6 ISATAP Enable (see page 34)
5. IPv6 ISATAP Interface Show (see page 35)
6. IPv6 Default Gateway (see page 36)
To open this screen:
1. From the Switch Main Menu, select 1. System Configuration.
2. From the System Configuration Menu, select 6. IP Configuration.
3. From the IP Configuration menu, select 2. IPv6 Address Configuration.
IPv6 Interface Enable
You can use the IPv6 Interface Enable screen to enable or disable the IPv6 interface.
To open this screen:
1. On the Switch Main Menu, select 6. IP Configuration.
2. On the IP Configuration menu, select 2. IPv6 Address Configuration.
3. On the IPv6 Address Configuration menu, select 1. IPv6 Interface Enable.
To edit the IPv6 interface settings:
1. When you finish using this Select Edit., and then make the changes. Press the Tab key to
move the cursor from one field to the next.
NOTE: To enable or disable the interface, move the cursor to the field, and then press the
Space Bar to toggle between ENABLE and DISABLE. If you select ENABLE, a warning
appears. Press the Enter key to acknowledge the warning.
2. Press the Esc key to move the cursor to the Action list.
SFE2010/SFE2010P Administration Guide
Using the Console
System Configuration
32