Table of Contents
Advertisement
9. Press the Enter / Information button.
● Set the time
Using the control panel, follow the steps below to set up the
time.
1. Press the Menu button.
2. Press the Select button and display "CLOCK ADJ".
CLOCK ADJ
3. Press the Enter / Information button.
4. Press the Select button and adjust "hour" digits.
12 : 00
5. Press the Enter / Information button.
6. Press the Select button and adjust "minute" digits.
12 : 55
7. Press the Enter / Information button.
8. Press the Select button and select "
12H 24H
9. Press the Enter / Information button.
LISTENING TO RADIO BROADCASTS
● Selecting FM or AM bandwidth
1. Power ON.
2. Press the Source select button and select the radio's
bandwidth (FM/AM).
● Selecting stations
Auto station selection
A long press of the Search button will automatically scan and
search clear station broadcast frequencies. To select the
next station broadcast, long press the Search button again.
(Long Press)
Manual station selection
Press the Search button to change frequencies and select
a station.
Preset station selection
Press the Select button to quickly switch between preset
stations.
At the time of purchase, there are no preset stations. Follow
the steps below to register preset stations.
<Manual preset registration>
1. Tune into a radio station of your choice and press the
Menu button.
2. Press the Select button and display "PRESET".
3. Press the Enter / Information button.
4. Press the Select button and select a preset number from
0 to 9 for registering the station.
5. Press the Enter / Information button to register the
station.
<Auto preset registration>
This feature allows the automatic registration of available
radio stations in the area of use.
(Maximum of 10 stations)
1. Press the Menu button.
2. Press the Select button and display "AUTO SCAN".
" or "
"
3. Press the Enter / Information button to begin auto preset
registration of available radio stations.
NOTE
○ A broadcasting radio station will not be registered if its
frequency is weak.
○ Depending on location of use, non-radio signals such as
noise may be registered.
○ See page 10 when recharging with USB in "
mode.
● For better reception
FM broadcasts
Adjust reception by changing the facing and angle of the
antenna.
"STEREO" will be displayed when receiving a stereo
broadcast.
Switching to monaural reception can reduce noise.
<Switching to monaural reception>
1. Press the Menu button.
2. Press the Select button and display "STEREO".
3. Press the Enter / Information button.
4. Press the Select button and display "
5. Press the Enter / Information button to complete setup.
AM broadcasts
Move the device and face it in a direction in which the
reception is best.
8
PRESET
PRESET 2
AUTO SCAN
STEREO
" .
OFF
"
Advertisement
Table of Contents
