Table of Contents
Advertisement
Steps to Install the
To install and configure the Slim Tap, you will do the following:
•
Unpack and inspect the Slim Tap .
•
Connect the Slim Tap to the network .
•
Power on the Slim Tap .
•
Connect a DB-9 cable from the Slim Tap to a computer and set configura-
tion thresholds . (See pages 7-8 for CLI settings)
•
Check utilization on Ports A & B from the CLI and from the Slim Tap, and
display the highest recorded utilization since the last reset .
•
Display link status for Ports A & B from the CLI .
•
Use the Reset Button to clear the highest recorded utilization and turn off
alarm LEDs . To use the reset button users must be logged in to the unit via
the RS232 connection .
•
Connect a monitoring device to the Slim Tap .
Unpack and Inspect the Slim Tap
Unpack the 10/100BaseT Slim Tap and check for damaged or missing parts .
The Tap ships with the following:
•
10/100BaseT Slim Tap
•
2 power supplies
•
2 power cords
•
2 network cables
•
2 monitor cables
•
RS232 DB-9 cable for use with the Command Line Interface
•
This Installation Guide
You may have also ordered a panel for rack mounting and an extended war-
ranty . Carefully check the packing slip against parts received . If any part is
missing or damaged, contact Net Optics' Customer Service immediately .
10/100BaseT Slim Tap
10/100 BaseT Slim Tap
Advertisement
Table of Contents
