Connect The Monitoring Device To The Slim Tap - Net Optics 10/100BaseT Slim Tap Installation Manual

11 . Press i to reset network port B alarm (see below) .
12 . To reset both network ports simultaneously press the reset button on the
front of the unit .
NOTE: _______________________________________________________________
If auto-negotiation is turned off on one of the network device, then it must also
be turned off on the other network device.
______________________________________________________________________

Connect the Monitoring Device to the Slim Tap

1 . Connect Monitor Port A to the appropriate port on the monitoring device
using a CAT5 straight-through cable .
2 . Connect Monitor Port B to the appropriate port on the monitoring device
using a CAT5 straight-through cable .
10/100 Tap 10/100 Tap
www.netoptics.com
Figure 8: Connecting the Slim Tap to the monitoring device
To monitor NIC
To monitor NIC
11
10/100 BaseT Slim Tap