Quitting The System - Pioneer DDJ-WEGO3 Operating Instructions Manual

Dj controller

Hide thumbs Also See for DDJ-WEGO3:

Operating instructions manual (44 pages)

Operation manual (12 pages)

Setup manual (4 pages)

Table Of Contents

Table of Contents

Enlarged version

Playing tracks and outputting the sound

The following describes the procedure for outputting the sound of the

left deck as an example.

! Set the volume of the device connected to the [MASTER OUT] ter-

minals (power amplifier, powered speakers, etc.) to an appropriate

level. Note that the output sound may be loud if the volume is set too

high.

Mixer section

3 MIC VOL control

4 EQ (HI, MID, LOW) controls

5 HEADPHONES VOL control

6 HEADPHONES SELECT A button

7 Channel fader

8 Crossfader

9 MASTER VOL control

1 Set the positions of the controls, etc., as shown below.

Names of controls, etc.

EQ (HI, MID, LOW) controls

Channel fader

Crossfader

MASTER VOL control

2 Press the play/pause button to play the track.

3 Move the channel fader away from you.

4 Turn the [MASTER VOL] control to adjust the audio

level of the speakers.

Adjust the audio level output from the [MASTER OUT] terminals to an

appropriate level.

Position

Center

Moved forward

Left edge

Turned fully counterclockwise

Monitoring sound with headphones

1 Set the positions of the controls, etc., as shown below.

Names of controls, etc.

HEADPHONES VOL control

2 Press the [HEADPHONES SELECT A] button.

3 Turn the [HEADPHONES VOL] control.

Adjust the sound level output from the headphones to an appropriate

level.

Inputting the sound of the microphone

The sound of the microphone connected to the [MIC] terminal can be

mixed.

1 Connect the microphone to the [MIC] terminal.

2 Adjust the audio level input to the [MIC] terminal.

! Turn the [MIC VOL] control: The [MIC] terminal's input audio level is

adjusted.

! Only the volume of the microphone's sound can be adjusted.

! The sound of the microphone is not output from the headphones.