Backrest; Q.angle Adjustable Backrest - Quickie Q2 Lite Owner's Manual

Q UI C KIE 2 L ITE
49
P. BACKREST
1. Height Adjustment
a. Remove the backrest upholstery from the frame.
b. You will see the backrest tube which telescopes into the frame and is secured by a screw (A) on
the side of the frame.
c. There are holes 1 inch apart that you may choose from to set the back height.
d. Remove the two backrest bolts from the rear frame tubes.
e. After selecting the proper height, insert bolt through frame and backrest tube.
f. Slide the backrest upholstery back over both backrest tubes.
NOTE– Use a torque setting of 144 in-lbs. when adjusting backrest.
Q. ANGLE ADJUSTABLE BACKREST (Option)
50
1. Angle Adjustment
a. Loosen button head screws (B) until the eccentric offset washer (C) moves freely.
b. Adjust backrest to desired angle, aligning eccentric offset washer in slot.
c. Tighten button head screws.
d. Repeat for opposite side.
2. Pivot Point Height Adjustment
a. Remove button head screw (D) from the frame.
b. Adjust backrest to obtain desired pivot point height.
c. Replace and tighten button head screw.
d. Repeat for opposite side.
3. Angle Adjustable Backrest Height Adjustment
a. Remove button head screw (E).
b. Adjust back tube to desired height.
c. Replace and tighten button head screw.
d. Repeat for opposite side.
NOTE– Use a torque setting of 144 in-lbs. when adjusting backrest.
MK-100071 RevC
51
52
IX. DEALER SERVICE AND ADJUSTMENT
24
49
50
51
52