Tilt-In-Space Mechanism; Backrest And Stroller Handle - Quickie SR45 Owner's Manual

SR4 5
J. TILT-IN-SPACE MECHANISM
The tilt-in-space mechanism is installed by Sunrise. Two cable/trigger mechanisms positively lock the chair in
place from 0º to 45º depending on the set-up.
1. Rocker Cover removal
a. Remove the (4 or 5) screws (A) that hold the cover to the Rocker Frame (B).
b. Remove the Rocker Cover (C) and store with screws in case you need them later.
35
2. Tilt-stops Adjustment
NOTE– When using tilt stops, you must first remove the Rocker Cover.
Adjustments can be made to limit the amount of tilt (rotation) that the chair provides by using the tilt-stops (E).
a. Loosen and remove the retaining screw (D).
b. Locate the tilt-stops to the desired limit either anterior or posterior.
c. Each half of tilt stop assembly should plug into directly opposing holes on the rocker (B), then secure in
place by tightening the screw (D).
36
3. Cable Adjustment
NOTE– Do not use lubricants on the components or assembly.
a. Loosen the jam nut (G).
b. Rotate the cable adjuster (F) until slack is removed from the cable. Make sure the plunger pin can fully
extend and retract after adjustment and that pins engage the rocker when triggers are released.
c. Tighten jam nut (G).
K. BACKREST AND STROLLER HANDLE
37
1. Angle Adjustment
a. Loosen rear bolt (H).
b. Loosen and remove angle adjustment bolt ( I ).
c. Set backrest at desired angle using pre-set holes.
d. Replace and tighten the front bolt ( I ).
e. Tighten rear bolt (H).
f. Repeat on other side.
IMPORTANT NOTE– The adjustment on each side of the chair should be exactly equal.
NOTE– Use a torque setting of 240 in.-lbs. When setting-up the angle adjustment of the stroller handle.
NOTE– Backrest position may also need adjusting to maintain optimal CG alignment and stability.
2. Angle Adjustment of the Stroller Handle
Depress both black push buttons ( J ) at the same time. This disengages the stroller handle and allows it to rotate
freely. Releasing the push buttons positively locks the adjustable stroller handle in the desired position.
38
3. Height Adjustment
a. Remove both bolts (K) from the backrest tube (one on each side).
b. Reposition backrest height.
c. Re-tighten both bolts (K) in the desired location.
34
38
IX. DEALER SERVICE & ADJUSTMENT
21
C
B A
B
D
G
F
H
I
K
J
118611 Rev. D
34
35
36
37
38