3. Technical Brief 3.2.7. GPIO map Over a hundred allowable resources, GD310 is using as follows except dedicated to SIM and Memory. GD310 GPIO(General Purpose Input/Output) Map, describing application, I/O state, and enable level, is shown in below table Table 5. S-Gold3 GPIO pin Map...
VIHdet (Vbat-0.8 ~ Vbat-0.3) the above-mentioned bit won’t be set. To support Remote power on function for factory mass production, applied an analog switch as following figure. As monitoring the RPWRON and Key matrix KP_OUT(2) & KP_IN (0), GD310 system recognize whether remote power on or End-key pushed...
3. Technical Brief 3.5. SIM & uSD interface GD310 supports 1.8V & 2.9V plug in SIM, SIM interface scheme is shown in (Figure 8). SIM_IO, SIM_CLK, SIM_RST ports are used to communicate with BBP(S-Gold3) and the SIM power supply enabled by PMIC.
3. Technical Brief 3.6. Memory 1Gbit Flash & 512Mbit DDRAM employed on GD310 with 8 & 16 bit parallel data bus thru ADD(0) ~ ADD(26). The 1Gbit Nand Flash memory with DDRAM stacked device family offers multiple high-performance solutions. ADD[16:28]...
Figure 16. JTAG & ETM(Embedded Trace Module) interface connector In case of GD310 mass production, the JTAG & ETM interface connector will not be mount on board. That is only for developing and software debugging purpose.( It will not be mounted on mass production...
Need help?
Do you have a question about the GD310 and is the answer not in the manual?
Questions and answers