Dell OptiPlex 3020M Owner's Manual page 41

Option
Strong Password
Password Configuration
Password Bypass
Password Change
TPM Security
Computrace
Chassis Intrusion
CPU XD Support
Description
The drive does not have a password set by default.
• Enter the old password
• Enter the new password
• Confirm the new password
Enable strong password - This option is disabled by default.
This field controls the minimum and maximum number of characters
allowed for the admin and system passwords.
• Admin Password Min
• Admin Password Max
• System Password Min
• System Password Max
Allows you to bypass the System Password and the internal HDD password
prompts during a system restart. This option is disabled by default.
• Disabled - Always prompt for the system and internal HDD password
when they are set.
• Reboot Bypass - Bypass the password prompts on restarts (warm
boots).
NOTE: The system will always prompt for the system and internal
HDD passwords when powered on from the off state (a cold boot).
Also, the system will always prompt for passwords on any module bay
HDDs that may be present.
Allows you to determine whether changes to the system and hard disk
passwords are permitted when an administrator password is set.
• Allow Non-Admin Password Changes - This option is enabled by
default.
This option lets you control whether the Trusted Platform Module (TPM) in
the system is enabled and visible to the operating system.
TPM Security - This option is disabled by default.
NOTE: Activation, deactivation, and clear options are not affected if
you load the setup program's default values. Changes to this option
take effect immediately.
This field lets you activate or disable the BIOS module interface of the
optional Computrace Service from Absolute Software.
• Deactivate - This option is selected by default.
• Disable
• Activate
• Enable
• Disable
• On-Silent- This option is selected by default.
Allows you to enable or disable the execute disable mode of the processor.
41