Ir Code Learning; Rf Address Setting - HDL -MTIRW User Manual

When the process is complete the 2
menu of the Remote Control.

3.2 IR code learning

Steps：
a) Enter the IR code learning interface, see Fig.3
b) Point the front of the remote controller 1-2cm away from the front of the 3
remote controller.
c) Press the relevant button on the 3
controller to learn. If the operation is successful the remote will display "Learn OK, Key
enter try code", If the operation fails, the display will show "Learn interfere, try again".
d) Test Code: Check that the code has been learnt successfully, Press Test Code to
return to the previous menu.

3.3 RF address setting

Each RF Remote Controller has an address, the address range is 1~65534.
You can set up to four "receiving address" in each RF receiver, correspondingly, the RF
receiver can receive control commands from four matched RF Remote Controllers.
Fig. 4 RF remote controller's address setting
Remote Controller – User Manual
nd page of the DLP panel will not be visible on the
Fig.3 IR code learning
rd
party remote controller that you wish your HDL
User Manual
MTIRW IR/RF Remote Controller
RF remote controller's
address
IR code
learning
interface
rd party
4