HDL
®
2. Set parameters
Fig. 1 Home page
2.1 Hide or display page
Now hide the 2nd page of DLP panel, setting as follow:
After that, you can't find the page on the remote controller, so you can't
control the DLP panel's second page via remote controller.
2.2 IR code learning
Step:
1. Enter into the interface of IR code learning, see Fig.3
2. Transmitter port of learned remote controller face to that remote controller within 1-2cm
Press the button in learned remote controller to start learning IR code, If learn success
will display " Learn OK, Key enter try code. If failed will display " Learn interfere, try again" .
3. Test Code: check if learned successfully, Press Test Code to back previous menu
MTIRW IR/RF Remote Controller
BL Level:set the brightness of the LCD, the range is 0 to 10
Ø
Sound EN:if there is a voice when press the button.
Ø
Ø
Language:select Chinese or English of the remote
PageDisp:hide or display page, the default is all display
Ø
IR Learn:Toward other IR remote, can learn IR code.
Ø
Wifi Add: set the wifi address of the remote. The address range
Ø
is 1 to 65534, you can choice one address.
Upgrade: connect USB to PC, then upgrade firmware, you must
Ø
reset the remote after upgrade firmware.
The 4 direction buttons are select functions and parameters.
Ø
Fig. 2 Hide the DLP panel page
Fig.3 IR code learning
3
IR code learning
interface