Table of Contents
Advertisement
Control can be updated.
○
Switch：The remote can be powered on or off via its dedicated switch. The remote
d
also has a power saver function that darkens the LCD display if there is no input
for more than 10 seconds. If there is no input for a further 13 seconds the Remote
Control goes into standby mode, pressing any button will resume normal
operation.
Change button：Change between the home page and panel page.
○
e
Return button：Return to the previous step/page.
○
f
○
Control button： Buttons 1 to 8 control the corresponding buttons present on a HDL
g
DLP panel, buttons 9 and 0 are invalid in this function.
: Scroll up and down to select one of 6 various panels, or set parameters.
○
：
h
: Scroll left and right to set parameters, or select from the many pages
present on each panel.
: Confirmation button, after the parameters have been set pressing ok will
confirm and save them.
: LCD interface.
○
i
2. Technical Data
Electric Parameter ：
Charge power supply
Working current
Standby current
Frequency of IR
Frequency of RF
IR sending distance
RF sending distance
Battery
USB interface
Environmental Condition：
Working temperature
Working relative humidity
Storage temperature
Storage relative humidity
Remote Controller – User Manual
MTIRW IR/RF Remote Controller
300mA/DC5V (USB interface)
45mA
1mA
38KHz
433.1580MHz/433.93MHz
5m
100m
Lithium (3.7V, 1050mA)
Firmware upgrade and battery charging
0℃~45℃
Up to 90%
-20℃~+60℃
Up to 93%
User Manual
2
Advertisement
Table of Contents
