Before Use - TEFAL cook4me EPC03 Series Instruction Manual

Intelligent multicooker
Hide thumbs Also See for cook4me EPC03 Series:
Table of Contents

Advertisement

BeFOre Use

to open the product, turn the open/
install the appliance on a fl at dry surface
close handle on top of the lid, until
that is not hot. remove all the packaging,
the marking is in line with the open
stickers or different accessories inside and
padlock.
outside the appliance.
remove the appliance from its packaging and
read the instructions carefully before using the
product for the fi rst time.
1
6
5
2
3
4
CLean tHe diFFerent COmPOnents
1
cooking bowl
2
metal lid
3
valve cover
4
condensation trap
5
steam basket
6
Decompression ball
1
BeFOre Use
HOW tO
HOW tO disassemBLe
tHe metaL Lid:
disassemBLe
grip the lid sub-assembly holding it by the seal,
and unscrew the central nut in an anti-clockwise
and reassemBLe
direction. remove the nut then the lid.
tHe Lid
3
aCCessinG tHe deCOmPressiOn BaLL:
turn the ball cover, anti-clockwise, so as to bring the
I
marker into position
. lift
the cover up. remove the ball, and gently clean it, along with its seat, with water
and some washing-up liquid. Dry the ball using a soft cloth, then put it back
in position. Put the ball cover back in place, and the marker
I
in position
.
lock it by turning the ball cover so that the marker is opposite the pictogram
"closed"
.
2
HOW tO taKe tHe VaLVe COVer OFF:
clasp the valve cover by its middle part (as shown) ;
then turn it slightly to unclip it.
clean the valve cover, paying special attention to the inside
(check that there is no left over food).
4
5
PUttinG tHe metaL Lid
PUttinG tHe VaLVe COVer BaCK:
sUB-assemBLY BaCK in tO PLaCe:
take the valve cover as shown in the picture
(gripping the middle).
grip the lid sub-assembly by the seal as shown
line up the interior circular shape with the three
in the picture.
hooks and then push so that the valve cover clips
line up the lid with the central axis and press
on (you should hear a "clip" sound).
it fl at against the sub-assembly.
the valve cover must be right up against
Put the nut back on and turn it clockwise,
tightening it as far as it will go.
the inside of the lid.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents