Motorola LS3578 Product Reference Manual page 40

3 - 4 LS3578 Product Reference Guide
Troubleshooting (Continued)
Table 3-1
Problem
Scanner emits short low-short
high- short low-short high beep
sequence while it is being
programmed.
Scanner emits one short high
beep when it is not in use.
Cradle does not work after
following installation
procedures.
Battery does not charge.
NOTE If problems still occur, contact the distributor or the Motorola Solutions Global Customer Support Center.
See
Possible Causes
Out of ADF parameter
storage space.
Out of Synapse parameter
storage space.
In RS-232 mode, a <BEL>
character is received and
Beep on <BEL> option is
enabled.
Cradle is not receiving
power.
Cable connections are not
secure.
The scanner is not inserted
properly in the cradle.
Cradle is not properly
connected to the host.
Cradle is outside the
charging temperature range.
page xv for contact information.
Possible Solutions
Erase all rules and re-program with shorter rules.
Scan
Set Synapse Defaults
appropriate Synapse Interface Guide, for cables
no longer in use and re-program the scanner for
the current host interface.
Normal when Beep on <BEL> is enabled and the
scanner is in RS-232 mode.
Check system power.
Reinsert cables properly.
Reinsert scanner.
Check that host settings are correct, and connect
the cradle to the appropriate port on the host.
Charge within the recommended temperature of
32° to 104° F (0° to 40° C) nominal, 41° to 95° F
(5° to 35° C) ideal.
code, from the