Motorola LS3578 Product Reference Manual page 31

Standard Beeper Definitions (Continued)
Table 2-1
Beeper Sequence
Low beep
Low-high-high beeps
Short low-short high-short low-short high
beeps
ADF Programming Error Indications
Low-high-low-high beeps
Low-high-low beeps
Low-high beeps
Host Specific
USB Only
Four high beeps
Short low-short medium-short high
beeps (power-up sequence)
Short low-short medium-short high
beeps (power-up sequence) occur
more than once
RS-232 only
High-high-high-low beeps
High beep
Delete last saved rule. The current rule is left intact.
All rules have been deleted.
Out of host ADF parameter storage space. See Default
Parameters on page 5-4.
Out of rule memory. Erase some existing rules, then try to save
rule again. (It is not necessary to re-enter the current rule.)
An LS3578 scanner was inserted into an STB3478 cradle.
ADF transmit error. Cancel rule entry. Rule entry mode exited
because of an error or the user asked to exit rule entry.
Entry error, wrong bar code scanned. Re-enter criterion or action.
All previously entered criteria and actions are retained. Criteria or
action list is too long for a rule.
The scanner did not complete initialization. Wait several seconds
and scan again.
The scanner scanned a USB device type. The scanner must
establish communication with the bus before it can operate at the
highest power level.
The USB bus may cause power to the scanner to cycle on and off
more than once. This is normal and usually happens when the
host PC cold boots.
RS-232 receive error.
A <BEL> character is received and Beep on <BEL> is enabled
(Point-to-Point mode only).
Scanning
Indication
2 - 3