Power Button Board - HP 350 G2 Maintenance And Service Manual

3. Remove the Philllips PM2.0×2.0 broad head screw (2) that secures the card reader board to the
top cover.
4. Remove the card reader board (3) and cable.
Reverse this procedure to install the card reader board.

Power button board

Description
Power button board (includes cable and double-sided adhesive)
Before removing the power button board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the Battery (see
a. Service cover (see
b. Hard drive (see
c. Optical drive (see
d. Keyboard (see
e. Top cover (see
Remove the power button board:
Battery on page 30), and then remove the following components:
Service cover on page
Hard drive on page 32)
Optical drive on page
Keyboard on page 39)
Top cover on page 42)
31)
37)
Component replacement procedures
Spare part number
758044-001
49