Environmental Information - Husqvarna ROYAL 53S INTEK Operator's Manual

The engine brake cable should always be
adjusted to stop the engine within 3 sec.
CAUTION! For adjustment contact your
authorized service dealer.
At the End of the Mowing Season
1. Replace blade, bolts, nuts or screws, if necessary.
2. Clean your lawnmower thoroughly.
3. Ask your local service dealer to clean the air
filter thoroughly and carry out any service or
repairs required.
4. Drain engine of oil and gasoline.
Storing your Lawnmower
1. Do not store your lawnmower immediately after use.
2. Wait until the engine has cooled to avoid a
potential fire hazard.
3. Disconnect the spark plug lead.
4. Clean your lawnmower
5. Loosen handle adjusters (A2) on both sides of
the product and fold the handle forward.(M)
6. Store in a cool, dry place where your lawnmower
is protected from damage.
Service Recommendations
Your product is uniquely identified by a silver and
black product rating label.
We strongly recommend that your product is
serviced at least every twelve months, more often in
a professional application.
Engine Maintenance Schedule
Follow the hourly or calendar intervals, whichever
occur first. More frequent service is required when
operating in adverse conditions
First 5 hours - Change oil.
Every 5 hours or daily - Check oil lever. Clean
finger guard. Clean around muffler.
Every 25 hours or every season - Change oil if
operating under heavy load or high ambient
temperature. Service air cleaner.
Every 50 hours or every season - Change oil.
Inspect spark arrester, if equipped.
Every 100 hours or every season - Clean cooling
system*. Replace spark plug.
* Clean more often under dusty conditions, or
when airborne debris is present or after
prolonged operation cutting tall, dry grass.
Engine Servicing & Guarantee
The engine fitted to your lawnmower is
guaranteed by the Engine Manufacturer. To
obtain further information contact your dealer.
Electrolux Outdoor Products are manufactured
under an Environmental Management System (ISO
14001) using, where practical, components
manufactured in the most environmentally
responsible manner, according to company
procedures, and with the potential for recycling at
the end of the products' life.
• Packaging is recyclable and plastic components
have been labelled (where practical) for
categorised recycling.
• Awareness of the environment must be
considered when disposing of 'end-of-life'
product.
• If necessary, contact your local authority for
disposal information.
Maintenance
Trouble Shooting
Engine Will Not Start
1.
2.
3.
4.
5.
6.
7.
8.
Lack of Engine Power and/or Overheating
1.
2.
3.
4.
5.
6.
7.
Excessive Vibration
1.
2.
3.
4.
5.

Environmental Information

DISPOSAL OF FUELS AND LUBRICATING OILS
• Wear protective clothing when handling any fuels
• Avoid contact with skin.
• Remove gasoline and engine oil before
• Contact your local authority for information of
• Do NOT dispose of used fuels/oils with
• Waste fuels/oils are harmful, but can be
• Do NOT dispose of used fuels/oils to water.
• Do NOT incinerate
Ensure OPC Lever is in the start position.
Check that the control lever is in the '+' position
Check that there is sufficient fuel in the tank
and the cap air vent is clear.
Remove and dry the spark plug.
Gasoline may be stale, replace. Once gasoline
has been replaced, it may take a little time for
fresh gasoline to filter through.
Check that the blade bolt is tight. A loose bolt
could cause difficult starting.
If the engine will still not start, immediately
disconnect the spark plug lead.
CONSULT YOUR LOCAL APPROVED
SERVICE DEALER.
Check that the control lever is in the 'normal'
position.
Disconnect the spark plug lead and allow the
engine to cool down.
Clean grass clippings and debris from around
the engine and air inlets and the underside of
the deck including the chute.
Clean the engine air filter (Ask your local
Approved Service Dealer to clean the engine air
filter thoroughly).
Gasoline may be stale, replace. Once gasoline
has been replaced, it may take a little time for
fresh gasoline to filter through.
If the engine still lacks power and/or is
overheating, Immediately disconnect the
spark plug lead.
CONSULT YOUR LOCAL APPROVED
SERVICE DEALER.
Disconnect the spark plug lead.
Check that the blade is correctly fitted.
If the blade is damaged or worn replace it with
a new one.
If vibration persists, immediately disconnect
the spark plug lead.
CONSULT YOUR LOCAL APPROVED
SERVICE DEALER.
and lubricants.
transporting the product.
your nearest Recycling/Disposal Station.
household waste
recycled and should be disposed of through
the recognised facilities.
8