Combination Switch; Mixing Ratio - Mercedes-Benz 1989 560 SL Owner's Manual

Combination Switch
Low beam (with exterior lamp
switch turned to position 2)
2 High beam (with exterior lamp
switch turned to position 2)
3 High beam flasher (high beam
available independent of exterior
lamp switch position)
4 Turn signals, right
5 Turn signals, left
To operate the turn signals, move
the combination switch past the
point of resistance (up or down).
The switch is automatically can-
celled when the steering wheel is
turned to a large enough degree.
9684
To signal minor directional changes
of the vehicle, such as changing
lanes on a highway, move combina-
tion switch to the point of resis-
tance only and hold it there.
6 Control for windshield washer
system
When the washer system is
switched on, the wipers also
operate.
The windshield washer nozzles
are automatically heated.
7 Windshield wiper control
o
Wiper off
I Intermittent wiping
II Normal wiper speed
III Fast wiper speed
Note:
If one of the turn signals fails, the
turn signal indicator system flashes
and sounds at a faster rate than
normal. In addition, the lamp failure
indicator will come on.
If the windshield wipers smear the
windshield, even during rain, acti-
vate the washer system as often as
necessary. The fluid in the washer
reservoir should be mixed in the
correct ratio.
Mixing ratio
For temperatures above freezing:
MB Windshield Washer Concen-
trate "S" and water
1 part "S" to 1 00 parts water
(40 ml "S" to 1 gallon water).
For temperatures below freezing:
MB Windshield Washer Concen-
trate "S" and commercially avail-
able premixed windshield washer
solvent/anti-freeze
1 part "S" to 100 parts solvent
(40 ml "S" to 1 gallon solvent).
41
I
c
o
~
W
Q.
o