Wireless Lan - Marantz M-CR511 Owner's Manual

Contents Connections

Wireless LAN

Internet
Router with access point
Front/Top
Rear panel
panel
Playback
Modem
To WAN side
Remote control 25
unit
Settings
0 With this unit, it is possible to use the DHCP and Auto IP functions to make the
network settings automatically.
0 When using this unit with the broadband router's DHCP function enabled, this unit
automatically performs the IP address setting and other settings. When using this
unit connected to a network with no DHCP function, make the settings for the IP
address, etc., at "Network". (v p. 84)
0 When using this unit, we recommend you use a router equipped with the following
functions:
0 Built-in DHCP server
This function automatically assigns IP addresses on the LAN.
0 Built-in 100BASE-TX switch
When connecting multiple devices, we recommend a switching hub with a
speed of 100 Mbps or greater.
0 Use only a shielded STP or ScTP LAN cable which is easily available at
electronics stores. (CAT-5 or greater recommended)
0 The normal shielded-type LAN cable is recommended. If a flat-type cable or
unshielded-type cable is used, other devices could be affected by noise.
0 When using a WPS (Wi-Fi Protected Setup) compatible router, you can connect
easily to Wi-Fi by pressing the Wi-Fi CONNECT button (WPS) on this unit. (See
the separate "Quick Setup Guide".)
Index
Tips Appendix