Quiet Operation - Haier AS26NC1HRA Operation Manual

Operation

QUIET Operation

SOFT
AM
QUIET
.
FAN
ECO
SPEED
QUIET
You can use this function when silence is needed for rest or
reading.
For each press, SOFT is displayed Air conditioner starts
POWER function operation. In SOFT operation mode, fan
speed automatically takes low speed of AUTO fan mode.
Press SOFT button again,
stops.
3
QUIET
QUIET Operation
SOFT disappears, the operation
COOL,HEAT and DRY Operation
AM
QUIET
.
FAN
ECO
SPEED
1. In DRY mode, when room temperature becomes
lower than temp. setting +2 ºC, unit will run
intermittently ai LOW speed regardless of FAN
setting.
2. Remote controller can memorize each operation
status. When starting it next time, just press ON/
OFF button and unit will run in previous status.
DRED Operation
(This function is unavailable on some models.)
Haier Peaksmart enabled air-conditioners have a Demand Response Mode display
on the indoor unit.
The display could be labelled d1, d2, d3 (wording may differ model to model).
These modes are described in more detail below:
M o e d D p s i y a l e D r c s t p i n o i
Your air-conditioner will continue
to cool or heat during the peak
DRM3 d3 demand event. The energy
consumed by your air-conditioner
is capped to 75%.
Your air-conditioner will continue
to cool or heat during the peak
DRM2 d2 demand event. The energy
consumed by your air-conditioner
is capped to 50%.
Your air-conditioner is still turned
on and the fan will continue to
DRM1 d1 operate. Your compressor is
turned off and cool/hot air will no
longer be generated
1
Unit start.
2
Select operation mode.
Press the COOL button on
the remote control.
Press the HEAT button on the
remote control.
Press the DRY button on the
remote control.
W h t a o t o d
No action is required.
No action is required.
DRM1 mode is only activated during
emergency demand management
situations. This mode will automatically reset
the device within 2 hours .If your air-con is in
this mode for longer than 2 hours please
contact Energex on 13 12 53.