Draytek Vigor2760 series User Manual page 159

Enable
Protocol
Interface
Interface Address
Src IP Start
Src IP End
Dest IP Start
Dest IP End
Dest Port Start
Dest Port End
Move UP/Move Down
Wizard Mode
Advance Mode
To use Wizard Mode, simple do the following steps:
1. Click the Wizard Mode radio button.
2. Click Index 1. The setting page will appear as follows:
Available settings are explained as follows:
Item
Source IP
Check this box to enable this policy.
Display the protocol used for this policy.
Display the interface to send packets to once the policy is
matched.
Display the WAN IP or WAN IP alias address which is
used as source IP of the outgoing packets.
Displays the IP address for the start of the source IP.
Displays the IP address for the end of the source IP.
Displays the IP address for the start of the destination IP.
Displays the IP address for the end of the destination IP.
Displays the IP address for the start of the destination port.
Displays the IP address for the end of the destination port.
Use Up or Down link to move the order of the policy.
Allows to configure frequently used settings of route policy
via three setting pages
Allows to configure detailed settings of route policy.
Description
Any – Any IP can be treated as the source IP.
Src IP Start - Type the source IP start for the specified
WAN interface.
Src IP End - Type the source IP end for the specified
WAN interface. If this field is blank, it means that all the
source IPs inside the LAN will be passed through the WAN
147 Vigor2760 Series User's Guide