8
Automatic Convenience Options
The Power Code PC 7500
enhance security and comfort. Some of these features are programmable
at the time of installation. Please see your installer for further details.
Illuminated Entry
When the alarm system is disarmed, the vehicle courtesy lights will turn
on for 1 minute, or until the vehicle is started or the system is re-armed.
Illuminated Exit
When removing the key from the ignition, the vehicle courtesy lights
will turn on for 1 minute, or until the Power Code PC 7500
Automatic Arming
The Power Code PC 7500
key is removed from the ignition. This feature can be temporarily
disabled by placing the system into Valet mode.
Ignition Lock
If all doors are closed and the vehicle is started with the key, the doors
will automatically lock.
Ignition Unlock
When removing the key from the ignition, the doors will automatically unlock.
When Your Security System is Triggered
The Power Code PC 7500
occurs while the system is armed:
• Any protected entrance is opened
• The vehicle ignition is turned on
• The vehicle is jolted hard enough to signal the impact detector
Once the alarm is triggered, the siren (or horn) sounds and the vehicle
parking lights flash for 30 seconds. The system will then re-arm, awaiting the
next intrusion attempt. To stop the siren while keeping the alarm armed
and doors locked, press the ARM button while the system is triggered.
The Interior Status Indicator
The Status Indicator is a high-intensity red light mounted in a visible
location on the vehicle dashboard. This red light gives a visual indication
of the alarm system's state of operation. Note the chart below:
If the Status Indicator is...
Flashing Green
Flashing Slowly
Flashing Very Quickly
Flashing Intermittently
(2 flashes, off, 2 flashes)
On (not flashing)
TM
performs a variety of automatic functions to
TM
will arm automatically 1 minute after the
TM
will trigger if one of the following events
....then the Security System
is disarmed
is armed
was triggered in your absence
(see Attempted Intrusion ID - page 4)
is in Valet mode(LED is Green)
is in Pre-arm mode
TM
is armed.
Need help?
Do you have a question about the PC 7500 and is the answer not in the manual?
Questions and answers