Compliance Information - Cisco ISB7000 Series Installation Manual

FCC Compliance
United States FCC Compliance
This device has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
such interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, it may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment OFF
and ON, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diff erent from
that to which the receiver is connected.
• Consult the service provider or an experienced radio/television
technician for help.
Any changes or modifi cations not expressly approved by Cisco
Systems, Inc., could void the user's authority to operate the
equipment.
For operation within 5.15 ~ 5.25 GHz frequency range, it is restricted
to indoor environment.
The information shown in the FCC Declaration of Conformity
paragraph below is a requirement of the FCC and is intended to
supply you with information regarding the FCC approval of this
device. The phone numbers listed are for FCC-related questions
only and not intended for questions regarding the connection or
operation for this device. Please contact your service provider for
any questions you may have regarding the operation or installation
of this device.
Declaration of Conformity
This device complies with Part 15 of FCC Rules. Operation is subject
to the following two conditions: 1) the device may not cause harmful
interference, and 2) the device must accept any interference
received, including interference that may cause undesired operation.
Cisco ISB7000 Series IP Set-Tops
Manufactured by: Cisco Systems, Inc.
5030 Sugarloaf Parkway
Lawrenceville, Georgia 30044 USA
Telephone: 770 236-1077
Canada EMI Regulation
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la class B est conforme à la norme
NMB-003 du Canada.
Software and Firmware Use
The software described in this document is protected by copyright
law and furnished to you under a license agreement. You may only
use or copy this software in accordance with the terms of your
license agreement.
The fi rmware in this equipment is protected by copyright law. You
may only use the fi rmware in the equipment in which it is provided.
Any reproduction or distribution of this fi rmware, or any portion of
it, without our express written consent is prohibited.
Disclaimer
Cisco Systems, Inc. assumes no responsibility for errors or omissions
that may appear in this guide. We reserve the right to change
this guide at any time without notice.
The maximum performance for wireless is derived from IEEE
Standard 802.11 specifi cations. Actual performance can vary,
including lower wireless network capacity, data throughput rate,
range and coverage. Performance depends on many factors,
conditions and variables, including distance from the access point,
volume of network traffi c, building materials and construction,
operating system used, mix of wireless products used, interference
and other adverse conditions.
20081121 FCC Standard
AVC VIDEO LICENSE
With respect to each AVC/H.264 product, we are obligated to provide
the following notice:
THIS PRODUCT IS LICENSED UNDER THE AVC PATENT PORTFOLIO
LICENSE FOR THE PERSONAL USE OF A CONSUMER OR OTHER
USES IN WHICH IT DOES NOT RECEIVE REMUNERATION TO (i)
ENCODE VIDEO IN COMPLIANCE WITH THE AVC STANDARD ("AVC
VIDEO") AND/OR (ii) DECODE AVC VIDEO THAT WAS ENCODED BY
A CONSUMER ENGAGED IN A PERSONAL ACTIVITY AND/OR WAS
O BTA I N E D F RO M A V I D E O P ROV I D E R L I C E N S E D TO
P ROV I D E AVC V I D E O. N O L I C E N S E I S G R A N T E D O R
SHALL BE IMPLIED FOR ANY OTHER USE. ADDITIONAL INFORMATION
M AY B E O B TA I N E D F R O M M P E G L A , L . L . C . S E E
HTTP://WWW.MPEGLA.COM.
Accordingly, please be advised that service providers, content providers,
and broadcasters may be required to obtain a separate use license
from MPEG LA prior to any use of AVC/H.264 encoders and/or
decoders.
®
ENERGY STAR
Cisco has tested and confi rmed that the ISB7000 set-top models
meet the Qualifi cation Criteria specifi ed in the ENERGY STAR
Program Requirements for Set-top Boxes Version 3.0.
ROVI CORPORATION COPYRIGHT
NOTICE
This product incorporates copyright protection technology that is
protected by U.S. patents and other intellectual property rights of
Rovi Corporation. Use of this copyright protection technology must
be authorized by Rovi Corporation, and is intended for home and
other limited viewing uses only unless otherwise authorized by Rovi
Corporation. Reverse engineering and disassembly are prohibited.
IC (Industry Canada) Notice
Notice: The Industry Canada (formerly Canadian Department of
Communications) label identifi es certifi ed equipment. This certifi cation
means that the equipment meets certain telecommunications network
protective, operational, and safety requirements. The department does
not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it
is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed
using an acceptable method of connection. In some cases, the
company's inside wiring associated with a single-line individual
service may be extended by means of a certifi ed connector assembly
(telephone extension cord). The customer should be aware that
compliance with the above conditions may not prevent degradation
of service in some situations.
Repairs to certifi ed equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any repairs
or alterations made by the user may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical
ground connections of the power utility, telephone lines and internal
metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such
connections themselves, but should contact the appropriate
electric inspection authority, or electrician, as appropriate.
This device complies with RSS-210 of the Industry Canada Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Caution:
The device for the band 5150-5250 MHz is only for indoor
usage to reduce potential for harmful interference to
co-channel mobile satellite systems.
The maximum antenna gain permitted (for devices in the bands
5250-5725 MHz (5.48 dBi) to comply with the e.i.r.p. limit; and
Notice
33