Cisco Explorer 8640HD Quick Reference Manual

IMPORTANT SAFETY INSTRUCTIONS
Notice to Installers
The servicing instructions in this notice are for use by qualifi ed service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions, unless you are qualifi ed to do so.
Note to System Installer
For this apparatus, the coaxial cable shield/screen shall be
grounded as close as practical to the point of entry of the cable
into the building. For products sold in the US and Canada, this
reminder is provided to call the system installer's attention to
Article 820-93 and Article 820-100 of the NEC (or Canadian
Electrical Code Part 1), which provides guidelines for proper
grounding of the coaxial cable shield.
This symbol is intended to alert you that uninsulated voltage
within this product may have sufficient magnitude to cause
electric shock.Therefore, it is dangerous to make any kind of
contact with any inside part of this product.
Ce symbole a pour but d'alerter toute personne qu'un contact
avec une pièce interne de ce produit, sous tension et non isolée,
pourrait être suffisant pour provoquer un choc électrique. Il est
donc dangereux d'être en contact avec toute pièce interne de
ce produit.
1) Read these instructions. Outdoor Grounding System
2) Keep these instructions. If this product connects to an outdoor antenna or cable system, be sure
the antenna or cable system is grounded (earthed). This provides some
3) Heed all warnings.
protection against voltage surges and built-up static charges.
4) Follow all instructions.
Article 810 of the National Electric Code (NEC) ANSI/NFPA No. 70-1990,
provides the following information:
5) Do not use this apparatus near water.
• Grounding of the mast and supporting structure
6) Clean only with dry cloth.
• Grounding the lead-in wire to an antenna discharge unit
7) Do not block any ventilation openings. Install in accordance
with the manufacturer's instructions.
• Size of the grounding conductors
8) Do not install near any heat sources such as radiators, heat • Location of the antenna-discharge unit
registers, stoves, or other apparatus (including amplifiers)
• Connection to grounding electrodes
that produce heat.
• Requirements for the grounding electrodes (see the following antenna
9) Do not defeat the safety purpose of the polarized or
grounding diagram as recommended by NEC ANSI/NFPA 70)
grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding-type plug has two
blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. If the provided
WARNING: Avoid electric shock and fire hazard! Do
plug does not fit into your outlet, consult an electrician for
not locate an outside antenna system in the vicinity of overhead
replacement of the obsolete outlet.
power lines or power circuits. Touching power lines or circuits
might be fatal.
10) Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11) Only use attachments/accessories specified by the
manufacturer.
12) Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid
injury from tip-over.
13) Unplug this apparatus during lightning storms or when
unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in any
way, such as a power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus,
the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
Protect the Product from Lightning
Power Source Warning
In addition to disconnecting the AC power from the wall outlet, disconnect
A label on this product indicates the correct power source for this product. the signal inputs.
Operate this product only from an electrical outlet with the voltage and
Verify the Power Source from the On/Off Power
frequency indicated on the product label. If you are uncertain of the type of
power supply to your home or business, consult your service provider or
Light
your local power company.
When the on/off power light is not illuminated, the apparatus may still be
The AC inlet on the unit must remain accessible and operable at all times.
connected to the power source. The light may go out when the apparatus
is turned off, regardless of whether it is still plugged into an AC power
Ground the Product
source.
Eliminate AC Mains Overloads
WARNING: Avoid electric shock and fi re hazard! If this product
connects to coaxial cable wiring, be sure the cable system is grounded
(earthed). Grounding provides some protection against voltage surges
WARNING: Avoid electric shock and fi re hazard! Do not
and built-up static charges.
overload AC mains, outlets, extension cords, or integral convenience
receptacles. For products that require battery power or other power
sources to operate them, refer to the operating instructions for
those products.
CAUTION: To reduce the risk of electric shock, do not
remove cover (or back). No user-serviceable parts
inside. Refer servicing to qualified service personnel.
WARNING
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE.
This symbol is intended to alert you of the presence
of important operating and maintenance (servicing)
instructions in the literature accompanying this product.
Ce symbole a pour but de vous avertir qu'une
documentation importante sur le fonctionnement et
l'entretien accompagne ce produit.
20080814_Installer820
Handling Disposable Batteries
This product may contain disposable batteries. Heed the following warning
and follow the Safety and Disposal instructions below.
WARNING: There is danger of explosion if the battery is
mishandled or incorrectly replaced. Replace only with the same type
of battery. Do not disassemble it or attempt to recharge it outside
the system. Do not crush, puncture, dispose of in fi re, short the
external contacts, or expose to water or other liquids. Dispose of
the battery in accordance with local regulations and instructions
from your service provider.
Safety
• Insert batteries correctly. There may be a risk of explosion if the batteries
are incorrectly inserted.
• Do not attempt to recharge 'disposable' or 'non-reusable' batteries.
• Please follow instructions provided for charging 'rechargeable'
batteries.
• Replace batteries with the same or equivalent type that we
recommend.
• Do not expose batteries to excessive heat (such as sunlight or fi re).
• Do not expose batteries to temperatures above 100°C (212°F).
Disposal
• The batteries may contain substances that could be harmful to the
environment.
• Recycle or dispose of batteries in accordance with the battery
manufacturer's instructions and local/national disposal and recycling
regulations.
• The batteries may contain perchlorate, a known hazardous substance,
so special handling and disposal of this product might be necessary.
For more information about perchlorate and best management
practices for perchlorate-containing substance, see www.dtsc.ca.gov/
T11518
hazardouswaste/perchlorate
Provide Ventilation and Select a Location
• Remove all packaging material before applying power to the product.
• Do not place this apparatus on a bed, sofa, rug, or similar surface.
• Do not place this apparatus on an unstable surface.
• Do not install this apparatus in an enclosure, such as a bookcase or rack,
unless the installation provides proper ventilation.
• Do not place entertainment devices (such as VCRs or DVDs), lamps,
books, vases with liquids, or other objects on top of this product.
• Do not block ventilation openings.
Protect from Exposure to Moisture and Foreign
Objects
WARNING: Avoid electric shock and fi re hazard! Do not
expose this product to dripping or splashing liquids, rain, or moisture.
Objects fi lled with liquids, such as vases, should not be placed on
this apparatus.
WARNING: Avoid electric shock and fi re hazard! Unplug
this product before cleaning. Do not use a liquid cleaner or an
aerosol cleaner. Do not use a magnetic/static cleaning device (dust
remover) to clean this product.
Cisco Explorer 8640HD, 8642HD, 8650HD,
and 8652HD High-Defi nition DVR Set-Tops
CH+
VOL- VOL+
POWER SELECT
CH-
The information shown in the FCC Declaration of Conformity paragraph
below is a requirement of the FCC and is intended to supply you with
information regarding the FCC approval of this device. The phone numbers
WARNING: Avoid electric shock and fi re hazard! Never
listed are for FCC-related questions only and not intended for questions
push objects through the openings in this product. Foreign objects
regarding the connection or operation for this device. Please contact your
can cause electrical shorts that can result in electric shock or fi re.
service provider for any questions you may have regarding the operation or
installation of this device.
Service Warnings
Declaration of Conformity
This device complies with Part 15 of FCC Rules. Operation is subject to the
WARNING: Avoid electric shock! Do not open the cover
following two conditions: 1) the device may not cause harmful interference,
of this product. Opening or removing the cover may expose you to
and 2) the device must accept any interference received, including
dangerous voltages. If you open the cover, your warranty will be
interference that may cause undesired operation.
void. This product contains no user-serviceable parts.
Check Product Safety
Upon completion of any service or repairs to this product, the service
technician must perform safety checks to determine that this product is in
proper operating condition.
Protect the Product When Moving It
Always disconnect the power source when moving the apparatus or
connecting or disconnecting cables.
20081112_Cable_Safety
Canada EMI Regulation
This Class B digital apparatus complies with Canadian ICES-003.
United States FCC Compliance
Cet appareil numérique de la class B est conforme à la norme NMB-003
This device has been tested and found to comply with the limits for a Class du Canada.
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against such interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy. If not installed and used in accordance with the
instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment OFF
and ON, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
Cisco, Cisco Systems, the Cisco logo, the Cisco Systems logo, Scientifi c Atlanta, and Explorer are registered trademarks or trademarks of Cisco Systems, Inc. and/or its affi liates
• Increase the separation between the equipment and receiver.
in the United States and certain other countries.
Manufactured under license from Dolby Laboratories. Dolby is a trademark of Dolby Laboratories.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. HDMI, the HDMI logo, and High-Defi nition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.
Macrovision is a registered trademark of Macrovision Corp.
• Consult the service provider or an experienced radio/television technician
MoCA is a trademark of the Multimedia over Coax Alliance.
for help.
All other trademarks mentioned in this document are the property of their respective owners.
Any changes or modifi cations not expressly approved by Cisco Systems,
Product and service availability is subject to change without notice.
Inc., could void the user's authority to operate the equipment.
© 2009 Cisco Systems, Inc. All rights reserved.
January 2009
GUIDE INFO EXIT LIST
L AUDIO IN R VIDEO IN
AVC VIDEO LICENSE
With respect to each AVC/H.264 product, we are obligated to provide the
following notice:
THIS PRODUCT IS LICENSED UNDER THE AVC PATENT PORTFOLIO LICENSE
FOR THE PERSONAL AND NON-COMMERCIAL USE OF A CONSUMER TO (i)
ENCODE VIDEO IN COMPLIANCE WITH THE AVC STANDARD ("AVC VIDEO")
AND/OR (ii) DECODE AVC VIDEO THAT WAS ENCODED BY A CONSUMER
ENGAGED IN A PERSONAL AND NON-COMMERCIAL ACTIVITY AND/OR WAS
OBTAINED FROM A VIDEO PROVIDER LICENSED TO PROVIDE AVC VIDEO.
NO LICENSE IS GRANTED OR SHALL BE IMPLIED FOR ANY OTHER USE.
ADDITIONAL INFORMATION MAY BE OBTAINED FROM MPEG LA, L.L.C. SEE
HTTP://WWW.MPEGLA.COM.
Accordingly, please be advised that service providers, content providers, and
broadcasters are required to obtain a separate use license from MPEG LA
prior to any use of AVC/H.264 encoders and/or decoders.
Cisco Explorer 8640HD, 8642HD, 8650HD,
and 8652HD High-Defi nition DVR Set-Tops
Macrovision Copyright Notice
Models: 8640HD, 8642HD, 8650HD, 8652HD
This product incorporates copyright protection technology that is protected
Manufactured by:
by U.S. patents and other intellectual property rights. Use of this copyright
Cisco Systems, Inc.
protection technology must be authorized by Macrovision, and is
5030 Sugarloaf Parkway
intended for home and other limited viewing uses only unless otherwise
Lawrenceville, Georgia 30044 USA
authorized by Macrovision. Reverse engineering or disassembly is
Telephone: 770-236-1077
prohibited.
Disclaimer
Cisco Systems, Inc. assumes no responsibility for errors or omissions that
may appear in this guide. We reserve the right to change this guide at any
time without notice.
20081121 FCC Standard
Service Provider Video Technology Group
5030 Sugarloaf Parkway, Box 465447
Lawrenceville, GA 30042
Printed in United States of America
Quick Reference Guide
Explorer 8652HD
678.277.1000
www.scientifi catlanta.com
Part Number 4026879 Rev B