Table of Contents
Advertisement
Chapter 4
Chapter 4:
Installation
Placement
The Access Point can be placed horizontally on a flat
surface such as a desktop so it sits on its four rubber feet
or it can be mounted on a wall.
Desktop Placement
Wall-Mount
The unit has two sets of wall-mount slots so that it can be
mounted either vertically or horizontally.
You will need 2 suitable screws to mount the Access
Point.
Suggested Mounting Hardware
4-5 mm
1-2 mm
NOTE:
Linksys is not responsible for damages
incurred by insecure wall-mounting hardware.
1.
Determine where you want to mount the Access Point.
Ensure that the wall you use is smooth, flat, dry and
sturdy and make sure the location is within reach of
the power outlet.
2.
Drill two holes into the wall for either vertical or
horizontal placement.
NOTE:
The printed Quick Installation Guide
that accompanies the Access Point includes
templates that can be used for spacing
between holes.
Wireless-G Access Point with Power Over Ethernet
Horizontal Mounting
NOTE:
The Access Point should be oriented as
shown above for horizontal mounting.
Vertical Mounting
NOTE:
The Access Point should be oriented as
shown above for vertical mounting.
3.
Insert a screw into each hole, and leave 3 mm of its
head exposed.
4.
Maneuver the Access Point so the wall-mount slots
line up with the two screws.
5.
Place the wall-mount slots over the screws and slide
the Access Point down until the screws fit snugly into
the wall-mount slots.
Installation
4
Hide quick links:
Advertisement
Table of Contents
