Table of Contents
Advertisement
LAPN300 is 12.5 W. Make sure your PoE switch or PoE injector is 802.3af-capable or
802.3at-capable to provide sufficient power to access point.
NOTE: When both PoE and AC power adapter are connected to access point, device
o
will get power from PoE as higher precedence.
Using Cat5e or better cable is highly recommended.
o
Reset Button—Press and hold this button for less than 15 seconds to power cycle device.
•
Press and hold for longer than 15 seconds to reset the device to factory default settings.
Mounting Guide
To avoid overheating, do not install your access point if ambient temperatures exceed 104°F (40°C).
Install on a flat, stable surface, near the center of your wireless coverage area making sure not to
block vents on the sides of the device enclosure.
Wall Installation
1. Position drilling layout template at the desired location.
2. Drill four screw holes on the mounting surface. If your Ethernet cable is routed behind the wall,
mark Ethernet cable hole as well.
3. Secure the mounting bracket on the wall with anchors and screws.
4. If your Ethernet cable is routed behind the wall, cut or drill the Ethernet cable hole you marked
in Step 2. Feed the Ethernet cable through the hole.
5. Connect the Ethernet cable and/or AC power adapter to your device.
6. Slide the device into the bracket. Turn clockwise until it locks into place.
Ceiling Installation
1. Select ceiling tile for mounting and remove tile.
2. Position drilling layout template at the desired location.
3. Drill four screw holes and Ethernet cable hole on the surface of ceiling tile.
4. Place back plate on the opposite side of ceiling tile. Secure mounting bracket to the ceiling tile
with flathead screw and nut. Route the Ethernet cable through the Ethernet cable hole.
6
Hide quick links:
Advertisement
Table of Contents
