Appendix; Error/Warning Messages; Salvaging Srmemory Cards For Which File Content Was Lost - Sony SRPC-5 Operation Manual

Appendix

Error/Warning Messages

When an abnormality is detected on the unit or VTR, a
yellow warning mark (
timecode (or picture ID) in the MEM CONTROL window
or VTR CONTROL window. Clicking the warning mark
displays the message as follows.
Error messages
Code Message
03 FAN STOP
04 POWER FAN
STOP
81 EPR PLD1 INITIAL
ERROR
82 EPR PLD2 INITIAL
ERROR
83 CN PLD1 INITIAL
ERROR
83 DC PLD1 INITIAL
ERROR
84 DM INTERFACE
ERROR
88 NVRAM
CHECKSUM
ERROR
38
Appendix
) flashes to the left of the
Description
A fan error was detected.
[PC5] An error was detected
with the fan located in the
power section.
[PC5] A PLD1 initialization error
was detected for the EPR-3
board.
[PC4] A PLD1 initialization error
was detected for the EPR-4
board.
[PC5] A PLD2 initialization error
was detected for the EPR-3
board.
[PC4] A PLD2 initialization error
was detected for the EPR-4
board.
[PC5] A PLD1 initialization error
was detected for the CN-3367
board.
[PC4] A PLD1 initialization error
was detected for the DC-161
board.
A communication error was
detected between the DM-145
and CPU.
An NVRAM (IC310) checksum
error was detected. IP address
and other configuration data
may be damaged.
Restart the unit using the
factory default settings
(IP address: 192.168.0.1;
subnet mask: 255.255.255.0;
MTU: 1500).
Warning messages
Code Message
11 EPR PLD1
TEMPERATURE
HIGH
12 DM PLD1
TEMPERATURE
HIGH
Salvaging SRMemory Cards for
which File Content was Lost
The unit incorporates a salvage function that is designed to
minimize data loss for SRMemory cards for which file
content was lost. The salvage function restores files based
on factors such as the maker information recorded on the
SRMemory card. The salvaging process can take as little
as a few seconds or up to 60 minutes, depending on the
conditions at the time recording was interrupted.
Notes
• The salvage function is intended to salvage as much
recorded material as possible in the event of an
unforeseen accident, but it does not guarantee 100%
restoration of data.
• This function will not restore data recorded immediately
preceding the recording interruption. The amount of data
lost will be as follows.
SR-Lite mode: Approx. 8 seconds of data
SR-SQ mode: Approx. 4 seconds of data
• Whenever you insert an SRMemory card that requires
salvaging or turn on the unit with such a card inserted, a
message asking whether you want to perform salvaging
will appear.
• Recording and playback are disabled for SRMemory
cards that require salvaging.
• When you format an SRMemory card, the memory card
will be ready for use immediately. However, any
previously recorded data will be lost.
To restore files via salvaging
1
Insert the SRMemory card for which file content was
lost into the SRMemory slot.
A warning massage and a message asking whether you
want to perform salvaging or formatting appear.
Description
[PC5] A PLD1 temperature
error was detected for the
EPR-3 board.
[PC4] A PLD1 temperature
error was detected for the
EPR-4 board.
A PLD1 temperature error was
detected for the DM-145 board.