Sony SRPC-5 Operation Manual page 44

11
Click the [Sharing] tab.
Verify that the "sr_files" folder is "Shared" and that
"\\Computer name\sr_files" appears for [Network
Path].
To configure network settings for Windows 7
Professional
1
Click [Control Panel] in the Start menu.
The Control Panel appears.
2
Click [Network and Internet].
3
Click [Network and Sharing Center].
4
Click [Change adapter settings].
5
Right-click [Local Area Connection], and click
[Properties] in the submenu.
6
Click [Internet Protocol Version 4 (TCP/IPv4)] to
select it in the [Local Area Connection Properties]
screen, and click the [Properties] button.
7
Click the [Use the following IP address] button to
select it in the [Internet Protocol Version 4 (TCP/IPv4)
Properties] screen, and enter the following for the IP
address and subnet mask.
IP address: 192.168.0.7
Subnet mask: 255.255.255.0
8
Click [OK].
To verify the network connection between the
SR-PC4/SRPC-5 and Windows 7
First, verify that the SR-PC4 or SRPC-5 is connected to the
Windows workstation via an Ethernet cable (CAT-5E),
and then verify the connection status between the SR-PC4/
SRPC-5 and Windows 7 Professional using a ping
command. Verify using the ping command as follows.
1
Enter "cmd" in the [Search programs and files] box of
the Start menu, and press the Enter key.
The DOS screen appears.
2
Enter "ping 192.168.0.5" and press the Enter key.
If the connection is properly established, "Reply from
192.168.0.5" appears.
If there is a problem with the connection, "Request
time out" appears.
44
Appendix
To change the initial settings of the SR-PC4/
SRPC-5
1
Open a Web browser, enter "192.168.0.5" in the
address bar, and press the Enter key.
The SR-PC4/SRPC-5 screen appears.
2
Click the [DIAGNOSIS] button.
3
Click the [NETWORK] tab, and enter the following
for [IP ADDRESS], [SUBNET MASK], and [MTU].
IP ADDRESS: 192.168.0.5
SUBNET MASK: 255.255.255.0
MTU: 1500
4
Click [SET].
5
When the confirmation message appears, click [OK].
6
Turn off the SR-PC4/SRPC-5, and then turn it on
again.
The settings are applied after the unit restarts.
To mount the shared folder
1
Open a Web browser, enter "192.168.0.1" (factory
default value) in the address bar, and press the Enter
key.
2
After connection is established, click the [DISK
SETUP] button.
3
Select "CIFS" in the [DISK SETUP] screen, and enter
the following for [SERVER IP], [SERVER DIR],
[USER NAME], and [PASSWORD].
SERVER IP: 192.168.0.7
SERVER DIR: sr_files
USER NAME: srpc
PASSWORD: sony1234
4
Click the [MOUNT] button.
A confirmation screen appears.
5
To verify whether the shared folder is properly
mounted, enter a directory name in the [MKDIR] box,
and click the [MKDIR] button.
Verify that the entered directory name has been
created and appears in the list.